Kunshan Xuan industry Da machinery introduction: our general resin material processing method
Resin processing are generally CNC processing, for no negative Angle resin body, three axis CNC milling machine and machining center can meet the processing requirements; For the resin body with negative Angle, it can be completed with a four-axis or 5-axis machining center, and can also be completed with a three-axis machining center for multiple clamping (in general, it is widely used to lift the whole owner model module processing).
Processing steps:
1. Check: before CNC processing, check whether the resin bonding is firm, and confirm whether the relative position of the two replacement wood is correct;
2. Selection of processing datum: the processing datum on the base plate of the instrument is used as the processing datum of the resin material (red surface below);
3. Rough machining: non-functional surface milling in place once, functional surface milling in general reserved processing allowance of 0.5mm-1mm;
4 finishing: each clamping must have a tool reference, and accurate alignment (0.02mm). For lettering and line engraving, the depth of line engraving is required to be 0.1mm and the width below 0.5mm:
Note: The resin processing drawing is only used as the interpretation of the machining accuracy of the profile, not as the basis for QC inspection and machining accuracy.
